Specifications

ppp set peer-addr
572 SSR Command Line Interface Reference Manual
ppp set peer-addr
Purpose
Set the peer address in case that IPCP/IPXCP can't resolve the address.
Format
ppp set peer-addr <IP address> ports <port>
Mode
Configure
Description
Issuing the ppp set peer-addr command allows you to set the peer address if it can't be
resolved by IPCP or IPXCP.
Parameters
<address> The IP or IPX address you wish to use.
<port> The port to which you wish to assign the address.
Restrictions
Usage is restricted to PPP port only.
Example
To assign an ip address 10.1.1.1/16 to slot 2, serial port 1:
ssr(config)# ppp set peer-addr ip-addr 10.1.1.1/16 ports se.2.1