Specifications

ppp set payload-compress
568 SSR Command Line Interface Reference Manual
ppp set payload-compress
Purpose
Enables packet compression for PPP ports.
Format
ppp set payload-compress [max-histories <number>] [type stac] ports <port list>
Mode
Configure
Description
The ppp set payload-compress command allows you to enable the Stacker payload
compression. You can enable compression on a single port, an entire multilink PPP (MLP)
bundle, or on individual ports that are members of a multilink PPP bundle. If this
command is not configured, payload compression is not enabled.
Parameters
<number>
Specifies the maximum number of compression history buffers to be kept. You can
specify either 0 or 1. Specifying 0 disables the keeping of any histories and each packet
is individually compressed. Specifying 1 allows a history buffer to be kept, which may
result in better compression. The default value is 1.
type stac
Specifies the Stacker (STAC LZS) compression algorithm. This is the default.
<port list>
The port(s) on which you want to enable payload compression. You can specify a
single port or a comma-separated list of ports.
Restrictions
Usage is restricted to PPP WAN ports only.