Specifications

port set
534 SSR Command Line Interface Reference Manual
port set
Purpose
Set port operating mode and port speed.
Format
port set [<port-list>|all-ports] [duplex full|half]
[speed 10Mbps|100Mbps|<number>] [auto-negotiation on|off]
[hash-mode m0|m1|m2|m3] [wan-encapsulation frame-relay|ppp] [ifg <number>]
[input-encapsulation forced-ethernet_ii] [link-timer <number>] [clock <clock-source>]
Mode
Configure
Description
Depending on the media type of a port, the port set command lets you set various
parameters of each port.
For 10/100-Mbps Ethernet, you can set the following:
• Operating mode (half-duplex or full-duplex).
• Port speed (10-Mbps or 100-Mbps). This parameter applies only to ports on the 10/100
line cards.
•Hash mode
Note:
By default, all ports use autosensing to detect the operating mode and speed of
the network segment to which they are connected. If you use this command to set
a port parameter, the setting disables autosensing for that parameter on the port.
For example, if you set the speed of a segment to 10-Mbps, that segment no longer
uses autosensing for the port speed and will always attempt to operate at 10-
Mbps.
For Gigabit Ethernet, you can set the following:
• Auto-negotiation
•Hash mode