Specifications

SSR Command Line Interface Reference Manual 473
nat set ftp-control-port
nat set ftp-control-port
Purpose
Specifies the port for FTP control.
Format
nat set ftp-control-port <port number>
Mode
Configure
Description
File Transfer Protocol (FTP) packets require special handling with NAT, because IP
address information is contained within the FTP packet data. You can use the nat set ftp-
control-port command to specify the port number that is used for FTP control.
The default port for FTP control is port 21.
Parameters
<port number>
Specifies the port number used for FTP control. Specify a value between 1 and 65535.
Restrictions
None.
Example
To set the FTP control port to 100:
ssr(config)# nat set ftp-control-port 100