Specifications

SSR Command Line Interface Reference Manual 415

lfap set server

Purpose

Sets one or more FAS IP addresses for the LFAP client to contact.

Format

lfap set server [“]<IP address> [<IP address>] [<IP address>][“]

Mode

Configure

Description

The lfap set server command allows you to set up to three FAS IP servers for the LFAP

client to contact.

Parameters

<IP address> Sets the IP address of the FAS servers to contact. You may specify a

maximum of three IP servers in the command line, separating each IP

address with a space. However, if you specify more than one IP server, you

must surround the IP addresses in the command line with double-quotes.

(See “Examples” below.)

Restrictions

At least one IP server must be configured before the LFAP client can be started. Also, in

order to delete an address from the list of IP servers to contact, you must enter a new lfap

set server command line. (Simply negating the previous lfap set server command will not

appropriately counter the initial command execution.)