Specifications

ip-router show route
362 SSR Command Line Interface Reference Manual
Restrictions
None.
Examples
A sample output of the ip-router show route detail command is shown below.
In this case there two routes to network 10.12.1.0/255.255.255.252 One of them is a direct
route and other route is learned through OSPF. The direct route has a better preference
(lower preference is considered better preference), and is thus the active route. The direct
route has been installed since 5 hours, 12 minutes and 10 seconds. This direct route is
being announced to the Forwarding Information Base (FIB) which is indicated by KRT,
over two RIP interfaces (which is indicated by 4-RIP.0.0.0.0+520, 5-RIP.0.0.0.0+520) and
also to the BGP internal peer-group for autonomous system 64805.
To see all the routes in the RIB, use the ip-router show rib command.
ssr# ip-router show route 10.12.1.0/255.255.255.252 detail
10.12.1 mask 255.255.255.252
entries 2 announce 1
TSI:
RIP 150.1.255.255mc <> metric 1
RIP 222.1.1.255mc <> metric 1
BGP_Sync_64805 dest 10.12.1/2 metric 0
BGP group type Routing AS 64805 no metrics
Instability Histories:
*Direct Preference: 0
*NextHop: 10.12.1.2 Interface: 10.12.1.2(to-c4500)
State: <Int Active Retain>
Age: 5:12:10 Metric: 0 Metric2: 0 Tag: 0
Task: IF
Announcement bits(5):
2-KRT 4-RIP.0.0.0.0+520 5-RIP.0.0.0.0+520
6-BGP_Sync_64805
7-BGP_Group_64805
AS Path: IGP (Id 1)
OSPF Preference: -10
*NextHop: 10.12.1.1 Interface: 10.12.1.2(to-c4500)
State: <NotInstall NoAdvise Int Hidden Gateway>
Local AS: 64805
Age: 1:20:05 Metric: 1 Metric2: -1 Tag: 0
Task: OSPF
AS Path: (64805) IGP (Id 9551)
Cost: 1 Area: 0.0.0.0 Type: Net AdvRouter:
172.23.1.14