Specifications

SSR Command Line Interface Reference Manual 361
ip-router show route
ip-router show route
Purpose
Displays the state of GateD.
Format
ip-router show route [ip-addr-mask|default] [detail]
Mode
Enable
Description
This command shows a specific route in the route-manager's routing information base
(RIB). For any given network, the routing daemon could have multiple routes. The active
route to any network is shown with a plus (+) sign next to it. The last active route is shown
with a minus (-) next to it. If a route has been the last active route and is also the current
active route, then it is shown with a asterisk (*) sign next to it. The legend is as follows:
• “+” Active Route
•“-”Last Active
• “*” Both
If the detail option is used, then additional information is displayed about this routes. The
announcements bits for the active route are shown which shows the protocol into which
this route is advertised.
Parameters
<ipAddr/mask>|default
Allows you to specify a particular IP address mask for the RIB route in question, or
refer to the default address mask.
detail
Allows you to view additional information about the routes in the RIB.