Specifications

ip-router policy redistribute
356 SSR Command Line Interface Reference Manual
ip-router policy redistribute
Purpose
Creates a simple route redistribution policy
Format
ip-router policy redistribute from-proto <protocol> to-proto <protocol> [network
<ipAddr/mask> [exact|refines|between <low-high>]] [metric <number>|restrict] [source-
as <number>] [target-as <number>] [tag] [ase-type]
Mode
Configure
Parameters
from-proto <protocol>
Specifies the protocol of the source routes. The values for the from-proto parameter
are rip, ospf, bgp, direct, static, aggregate, or ospf-ase.
to-proto <protocol>
Specifies the destination protocol where the routes are to be exported. The values for
the to-proto parameter are rip, ospf, or bgp.
network <ipAddr/mask>
Provides a means to define a filter for the routes to be distributed. The network
parameter defines a filter that is made up of an IP address and a mask. Routes that
match the filter are considered as eligible for redistribution.
Matching usually requires both an address and a mask, although the mask can be
implied. If no additional options qualifying the networks to be redistributed are
specified, then any destination that falls in the range implied by this network-
specification is matched, so the mask of the destination is ignored. If a natural network
is specified, the network, any subnets, and any hosts will be matched. If you specify the
exact, refines, or between parameters, the mask of the destination is also considered.
exact
This option specifies that the mask of the routes to be redistributed must match the
supplied mask exactly. This is used to match a network, but not subnets or hosts of
that network.