Specifications

ip-router policy export destination
352 SSR Command Line Interface Reference Manual
ip-router policy export destination
Purpose
Creates an export policy from the various building blocks.
Format
ip-router policy export destination <exp-dest-id>
[source <exp-src-id> [filter <filter-id>|[network <ipAddr/mask> [exact|refines|between
<low-high>] [metric <number>|restrict]]]]
Mode
Configure
Parameters
<exp-dest-id>
Is the identifier of the export-destination which determines where the routes are to be
exported. If no routes to a particular destination are to be exported, then no additional
parameters are required.
<exp-src-id>
If specified, is the identifier of the export-source which determines the source of the
exported routes. If a export-policy for a given export-destination has more than one
export-source, then the ip-router policy export destination <exp-dest-id> command
should be repeated for each <exp-src-id>.
<filter-id>
If specified, is the identifier of the route-filter associated with this export-policy. If
there is more than one route-filter for any export-destination and export-source
combination, then the ip-router policy export destination <exp-dest-id> source <exp-src-id>
command should be repeated for each <filter-id>.
network <ipAddr/mask>
Specifies networks which are to be exported. Matching usually requires both an
address and a mask, although the mask can be implied. If no additional options
qualifying the networks to be exported are specified, then any destination that falls in
the range implied by this network-specification is matched, so the mask of the
destination is ignored. If a natural network is specified, the network, any subnets, and
any hosts will be matched. If you specify the exact, refines, or between parameters,
the mask of the destination is also considered.