Specifications

SSR Command Line Interface Reference Manual 313
ip-router global set
ip-router global set
Purpose
Set various global parameters required by various protocols.
Format
ip-router global set <option-list>
Mode
Configure
Parameters
<option-list>
Specify one of the following:
autonomous-system <num1> loops <num2>
The autonomous system number. <num1> sets the as number for the router. It is
only required if the router is going to run BGP. Specify a number from 1 – 65534.
<num2> controls the number of times the as may appear in the as-path. Default is
1. It is only required if the router is going to run protocols that support as-path,
such as BGP.
router-id <hostname-or-IPaddr>
The router ID for use by BGP and OSPF. The most preferred address is any address
other than 127.0.0.1 on the loopback interface. If there are no secondary addresses
on the loopback interface, then the default router ID is set to the address of the first
interface which is in the up state that the SSR encounters (except the interface en0,
which is the Control Module’s interface). The address of a non point-to-point
interface is preferred over the local address of a point-to-point interface.
interface <interface-name>|all preference <num> down-preference <num> passive
autonomous-system <num>
Specify the following:
<interface-name>|all
Specify an interface that was added using the ip-router global add interface
command, or all for all interfaces.