Specifications

interface create ipx
258 SSR Command Line Interface Reference Manual
up
Sets the state of the interface to up. (This is the default state.)
down
Sets the state of the interface to down.
output-mac-encapsulation
The output MAC encapsulation associated with this interface. You can specify one of
the following:
– ethernet_ii (the default)
– ethernet_snap
– ethernet_802.2_ipx
mac-addr <MACaddr-spec>
Sets the MAC address for this interface. You can specify one of the following:
– A specific MAC address – specify the entire MAC address as follows:
xx:xx:xx:xx:xx:xx
– An offset from the base MAC address in the pool – specify the offset. For example,
to specify an offset of 10 from the base MAC address, enter “10”. For example, if
the base MAC address is 00:E0:63:02:00:00 and you specify an offset of 10, the SSR
assigns MAC address 00:E0:63:02:00:0A to the interface.
– The base MAC address – specify the basemac keyword. This is the default.
Restrictions
None.
Examples
The following commands create a VLAN called IPX10, add all the ports on the line card in
slot 1 to the VLAN, and create an IPX interface called “
int10” with the IPX address
a98d7c6f, associated with VLAN IPX10.
ssr(config)# vlan create IPX10 ipx
ssr(config)# vlan add ports et.1.* to IPX10
ssr(config)# interface create ipx int10 address a98d7c6f vlan IPX10