Specifications

interface add ip
252 SSR Command Line Interface Reference Manual
interface add ip
Purpose
Configure secondary addresses for an existing interface.
Format
interface add ip <InterfaceName> address-mask <ipAddr-mask> [broadcast <ipAddr>]
Mode
Configure
Description
The interface add ip command configures secondary addresses for an existing IP
interface.
Note:
The interface must already exist. To create an interface, enter the
interface create ip command.
Parameters
<InterfaceName> Name of the IP interface; for example, int4.
address-netmask IP address and netmask of this interface. You can specify the address
and mask information using the traditional format (example:
10.1.2.3/255.255.0.0) or the CIDR format (example: 10.1.2.3/16). If
you specify an address without mask information, the SSR uses the
natural mask for the address (/8 for Class A, /16 for Class B or /24
for Class C).
broadcast <ipAddr> Broadcast address of this interface.
Restrictions
You can use this command only on an interface that has already been created using the
interface create ip command.