Specifications

SSR Command Line Interface Reference Manual 229

frame-relay set peer-addr

Purpose

Set the peer address in case that InArp is not supported on the remote device.

Format

frame-relay set peer-addr <IP address> ports <port list>

Mode

Configure

Description

Issuing the frame-relay set peer-addr command allows you to set the peer address if it

can't be resolved by InArp.

Parameters

<IP address> The IP or IPX address you wish to use.

<port list> The location of the port to which you wish to assign the address.

Restrictions

Usage is restricted to frame relay VCs only.

Example

To assign an IP address 10.1.1.1/16 to slot 2, VC 100 on serial port 1:

ssr(config)# frame-relay set peer-addr ip-addr 10.1.1.1/16 ports

se.2.1.100