Specifications

SSR Command Line Interface Reference Manual 227
frame-relay set lmi
full-enquiry-interval <number>
The number of status enquiries that will be sent before a full report on status is
compiled and transmitted.
monitored-events <number>
The number of status enquiries over which collection and tabulation of various pieces
of LMI information will take place.
polling-interval <number>
The amount of time (in seconds) that will pass before a subsequent status enquiry
takes place.
state enabled|disabled
Enables the sending and receiving of LMI messages. If LMI messages are enabled, the
operational status of each VC is determined by the LMI messages. If LMI messages
are disabled, each VC is assumed to be operationally “up”. LMI messages are disabled
by default.
type ansi617d-1994|q933a|rev1
The LMI type for frame relay WAN ports. You can only specify the ansi617d-1994,
q933a, or rev1 keywords to define as the LMI type for WAN ports.
port <port list>
The port or ports that will assume the LMI service profile behavior.
Restrictions
None.
Examples
To set the number of status enquiries that will be sent before compilation and
transmission of a full status report for serial port 2 of slot 2 to 75 enquiries:
ssr(config)# frame-relay set lmi full-enquiry-interval 75 port se.2.2