Specifications

frame-relay set lmi
226 SSR Command Line Interface Reference Manual
frame-relay set lmi
Purpose
Set frame relay Local Management Interface (LMI) parameters.
Format
frame-relay set lmi [error-threshold <number>] [full-enquiry-interval <number>]
[monitored-events <number>] [polling-interval <number>] [state enabled|disabled]
[type ansi617d-1994|q933a|rev1] port <port list>
Mode
Configure
Description
The frame-relay set lmi command allows you to specify the following attributes:
• The number of times the router will attempt to poll an LMI interface before declaring
it down. You can define a value between 1 and 10, inclusive.
• The number of status enquiries that will be sent before a full status enquiry is
requested. You can define a value between 1 and 255, inclusive.
• The number of status enquiries over which various pieces of LMI information can be
collected and tabulated. For example, you can tabulate the number of times an
interface was declared down/lost due to a lack of proper responses to status enquiries.
You can define a value between 1 and 10, inclusive.
• The number of seconds that pass between successive status enquiry messages. You can
define a value between 5 and 30, inclusive.
• Whether or not LMI messages are sent. LMI messages are not sent by default.
• The LMI type for frame relay WAN ports.
Parameters
error-threshold <number>
The number of unanswered status enquiries that the router will make before declaring
an interface to be down.