Specifications

SSR Command Line Interface Reference Manual 219
frame-relay apply service ports
frame-relay apply service ports
Purpose
Apply a pre-defined service profile to a frame relay virtual circuit (VC).
Format
frame-relay apply service <service name> ports <port list>
Mode
Configure
Description
Issuing the frame-relay apply service command allows you to apply a previously defined
service profile to a given frame relay VC.
Parameters
<service name> The name of the previously defined service profile you wish to apply to
the given port(s) or interfaces.
<port list> The port(s) to which you wish to apply the pre-defined service profile.
You can specify a single VC or a comma-separated list of VCs.
Restrictions
Usage is restricted to frame relay VCs only.
Example
To apply the service “s1” to slot 2, VC 100 on serial ports 1 and 2:
ssr(config)# frame-relay apply service s1 ports se.2.1.100, se.2.2.100