Specifications

SSR Command Line Interface Reference Manual 187

dvmrp show routes

Purpose

Displays DVMRP unicast routing table.

Format

dvmrp show routes host <IPaddr>|interface <IPaddr>|net <netaddr>|router <IPaddr>

subordinates|permission

Mode

Enable

Description

The dvmrp show routes command displays the contents of DVMRP unicast routing table.

DVMRP routes show the topology information for the internet multicasting sites. It is

independent of IP unicast routing table or protocol. In this table, the information is

presented about a address prefix (in form of network-address/network-mask length), the

interface and the uplink (parent) router through which this subnet can be reached. This

table also shows information about any routers/interfaces which consider this router as

their uplink (that is, those routers which depend on this router if traffic were to originate

from this subnet). These routers/interfaces are shown as children of the parent router.

Note:

The dvmrp show routes command can search on the basis of subnet and on the

basis of those routes whose parent is a particular interface and/or a particular

router.

Note:

This command only shows DVMRP routes and not information about current

multicast sessions. For information about current multicast sessions, use the

multicast show mroutes command.

Parameters

host <IPaddr> Displays the route to the specified uplink host address.

interface <IPaddr> Displays the interface address of the specified uplink interface.