Specifications

SSR Command Line Interface Reference Manual 173
Chapter 11
dvmrp Commands
The dvmrp commands let you configure and display information about Distance Vector
Multicast Routing Protocol (DVMRP) interfaces.
Command Summary
Table 8 lists the dvmrp commands. The sections following the table describe the command
syntax.
Table 8. dvmrp commands
dvmrp accept|noaccept route <IPaddr/mask> [exact] [interface <IPaddr> [router
<IPaddr>]]
dvmrp advertise|noadvertise route <IPaddr/mask> [exact] [interface <IPaddr>]
dvmrp create tunnel <name> local <IPaddr> remote <IPaddr>
dvmrp enable no-pruning
dvmrp enable interface <IPaddr>|<interface-name>|<tunnel-name>
dvmrp set interface <IPaddr>|<hostname> [metric <num>] [neighbor-timeout
<seconds>] [prunetime <seconds>] [rate <num>] [scope <IPaddr/mask>] [threshold
<num>]
dvmrp show interface [<IPaddr>]
dvmrp show routes host <IPaddr>|interface <IPaddr>|net <netaddr>|router <IPaddr>
dvmrp show rules
dvmrp start