Specifications

Application Views Fore Software Application (ForeSoftWreApp)
Device Management Page 95 ForeRunner ATM Switch Modules
Dtl Tag
This value specifies an index into a table of DTLs,
the DTL entries in this table will be used to setup
the SPVC.
Auto Dtl Status
The status of the dynamic path selection function
for this SPVC. Can be set to either enabled or
disabled. If set to disabled, auto path selection
will not be used.
PNNI SPVC Destination Table
View
Access: From the PNNI SPVC/SPVCP Configuration
view, click on the PNNI SPVC Dest button.
This table contains information about SPVCs that
have their destination at this switch.
Index
The value of this object uniquely identifies the
SPVCs that have this switch as their source.
Calling Port
The port of this terminating SPVC at the source
end. It has a value of -1 if the port at the
destination switch cannot be determined.
Calling VPI
The VPI to be used at the Calling NI for this SPVC.
Calling VCI
The VCI to be used at the Calling NI for this
SPVC.
Called Port
The port of this terminating SPVC at the
destination end. It has a value of -1 if the port at
the destination switch cannot be determined.
Assign VPI
The VPI assigned at the Called NI for this SPVC.
This value is only meaningful if the SPVC status
is up.
Assign VCI
The VCI assigned at the Called NI for this SPVC.
This value is only meaningful if the SPVC status
is up.
Calling ATM Address
The ATM Address to be used at the Calling NI for
this SPVC.
Called ATM Address
The ATM address of the distant end NI (remote
switch) for this SPVC.