Specifications

Application Views Fore Software Application (ForeSoftWreApp)
Device Management Page 83 ForeRunner ATM Switch Modules
Protocol
The signaling protocol that created this path.
TrShapeVPI
The VPI of shaped cells.
Min VCI
The minimum VCI that can be allocated on this
path.
Max VCI
The maximum VCI that can be allocated on this
path.
ATM Switch Path Route Table
View
Access: From the Software Switch Configuration view, click
on the Path Route button.
Signaling Path Table View
Port
Identifies the port of this signaling path, and is
the same as the portNumber.
VPI
The VPI (Virtual Path Identifier) of this signaling
path.
VCI
The VCI (Virtual Channel Identifier) of the
signaling channel within the signaling path.
CLS-VCI
The VCI of the connectionless channel within the
signaling path.
Admin
The desired state of this signaling channel. The
up state dictates that SPANS (Simple Protocol for
ATM Network Signalling) messages are used for
signalling. The down state dictates the SPANS
protocol is not used for signaling.
Oper
The current operational state of this signaling
channel, as determined either by administrative
action, when the value of a Admin is down, or by a
link monitoring protocol, when the value of Admin
is up.
Status
The status of this signaling path entry.
AALtype
The AAL (ATM Adaptation Layer) type that is used
by this signaling path.
CDV
The signaling path Cell Delay Variation (CDV)
specified in microseconds, indicates the time