Specifications

Application Views Fore Switch Application (ForeSwitchApp)
Device Management Page 63 ForeRunner ATM Switch Modules
Admin Max VCI
The maximum configured VCI used for SVCs.
Min VCI
The minimum actual VCI used for SVCs
Max VCI
The maximum actual VCI used for SVCs.
Rem IP Address
The remote IP address
Calling P deflt Addr
The calling party address to be inserted in
Connection Setup messages which do not contain
Calling Party Addresses.
Native E164 Address
The Native E164 Address for this uni.
Use Native E164
Whether to use Native Form of E164 Addresses
across this link. Used by public UNI. Possible
options are enable or disable.
E164 Addr Resolution
Whether to resolve Private NSAPs into Native
E164 addresses. If disabled, but if Use Native
E164 is enabled, then the only address
conversion performed at this UNI will be of Private
NSAPs in E.164 format.
UNI Config Version
The configuration version of the UNI protocol to
use at initialization. Configuring the UNI to auto,
means that the UNI will attempt to automatically
determine which version of the UNI protocol to
use by reading the value of ILMI variable UNI
version. Configuring to uni30 means that this link
will use version 30 of the UNI protocol, likewise
for uni31. If the nni interface has to be brought
up as pnni then pnni10 version is specified.
UNI Oper Version
The version of the UNI that is currently being
used on this link. Possible version are auto,
uni30, uni31, pnni10, and uni40.
Ft Pnni Orig Cost
The cost of each pnni orig loglink. It is configured
at originating end of sigPath.
Ft Pnni Term Cost
The cost of each pnni term loglink. The
originating side of a link informs the terminating
side of the configured Ft Pnni Orig Cost in a hello
message. The terminating side then uses the cost
value in the hello message as the Pnni Term Cost
for topology advertisement.
Sig Mode
The configured mode for signaling: VP-associated,
Non-Associated or auto mode. vpAssoc stands for