Specifications

Configuration Views Fore ATM SONET Application Configuration View
Device Management Page 46 ForeRunner ATM Switch Modules
Path Width
The type of the SONET path. The possible values
are sts1, sts3c, sts9c, sts12c, sts24c, or
sts48c. The default is sts3c.
Loopback
The current loopback status of the SONET
interface. The possible status entries are as
follows:
None - the interface is not in a loopback state
(default value)
Line - the receive data and clock are con-
nected to the transmit data and clock
Diag - the transmit data stream and clock are
looped back to the receiver
Other - the interface is in a loopback that is
not defined.
Tx Clock Source
The source of the transmit clock. The possible
values are Local or Rx. The default is Local.
Rx Scrambling
Indicates whether the information is being
descrambled on receiving. The possible values are
Descrambling or No Descrambling. The default
is Descrambling.
Tx Scrambling
Indicates whether the information is being
descrambled before transmitting. The possible
values are Scrambling or No Scrambling. The
default is Scrambling.
Section Stat
The section status of the interface. The possible
values are 1 (no defect), 2 (loss of signal detected),
or 4 (loss of frame detected). The default is 1.
Line Status
The line status of the interface. The possible
values are 1 (no defect), 2 (line alarm indication
signal detected), or 4 (line far end receive failure
detected). The default is 1.
Path Status
The path status of the interface. The possible
values are 1 (no defect), 2 (path loss of pointer
detected), 4 (path alarm indication signal
detected), or 8 (path yellow alarm detected). The
default is 1.