Specifications

Application Views Fore Software Application (ForeSoftWreApp)
Device Management Page 101 ForeRunner ATM Switch Modules
attempted for PVC switch over every pacing
interval.
AutoPVCSwOver
Allows you to determine if the automatic
switchover of the PVC portion is enabled or
disabled. The default value is disabled.
State
The state of the Redundancy Group.
operational indicates that this group is in the
normal state and switchover is not going on.
switchover_in_progress indicates that
switchover is presently going on for this group. In
this state no new SPVCs can be added to this
group.
RowStatus
The status of this group entry.
NSAP Static Route Table View
Access: From the Software Switch Configuration View,
click the NSAP Static Route button.
Address
Identifies the destination NSAP (Network Server
Access Point) address.
Mask
The mask that is used for this NSAP address.
Port
The port through which this NSAP address can be
reached.
VPI
This value identifies the path through which this
NSAP address can be reached.
Cost
The cost associated with this Static Route. This
cost is to be used as a metric while routing.
CBR Cap
The maximum capacity available on this route for
CBR connections.
Mx CBR Cap
The maximum capacity available on this route for
VBR connections.
AbrSupport
The capability to support ABR traffic on this
route.
EpdSupport
Displays the capability to support Early Packet
Discard (EPD) on this route. Possible values are
supported and unsupported.
Status
The status of this NSAP address. Setting this
object to invalid causes this address to
disappear.