Specifications

Application Views Fore Software Application (ForeSoftWreApp)
Device Management Page 100 ForeRunner ATM Switch Modules
RGroupIndex
Specifies the entry in the SPVXC Redundancy
Group table for information regarding the
secondary port to be used as the redundant port.
This will be used at the terminating PVC end.
PNNI SPVXC Redundancy Group
Table View
Access: From the PNNI SPVC/SPVCP Configuration
view, click on the Redundancy button.
A table of Primary to Secondary Port mappings
that will be used for redundancy in permanent
portion of SPVxCs.
Pri Port
The primary port of this entry. This will be used
as the primary PVC port for the SPVC created
with this group index.
Sec Port
The secondary port of this group. This will be
used as the redundant PVC port for the SPVC
created with this group index. During a switch,
the PVCs will be switched from primary port to
this port.
Name
The name that has been assigned for this group.
NSAP Address
The default NSAP address associated with this
group using the default domain’s prefix. This is a
read-only variable available to view the default
NSAP address associated with this group.
SwitchoverCmd
Defines the switchover command. The value of
switch2primary is used to switch over the
permanent PVC portion to the primary port. The
value of switch2secondary is used to switch
over the permanent PVC portion to the secondary
port. If the permanent portions are already on the
specified port, no action is taken.
ActivePort
The port that is active. This can take any one of
the primary or secondary port values. This is a
read only variable useful to check the currently
active port.
PacingNo
The pacing number of this group. During a pacing
interval, pacing number of SPVCs will be
attempted for PVC switch over.
PacingInt
The pacing interval in units of milliseconds for
this group. Every time a switchover command is
issued, pacing number of SPVCs will be