Specifications

Port Performance View
SNMP NB30 Remote Port Performance View
Performance Views
6-18
Cabletron SNMP Bridges
Management Module Guide
Two additional buttons are available from the NB30 Remote Port Performance
View, as follows:
The Port Diagnostics button accesses the DSX-1 Loopback Test View. The
DSX-1 Loopback Test View provides the following information:
Bridge Name
The name of the NB30. Default is CABLETRON REMOTE BRIDGE.
Network Address
The Internet Protocol (IP) address of the NB30.
Bridge Status
The status of the bridge (ON_LINE or STAND BY).
Testing Status
The current port testing status (Not_Testing, Testing, Network, Passed, or
Failed).
Single-click on this button to enable this option. This starts a loop back test.
Single-click on this button to enable this option. This stops loop back testing
and returns the device to service.
Select one of the valid parameters for this field, (Alternating_1/0s, All_1s,
All_0s, or Incrementing_Data) by clicking on this button and dragging to the
selection.
The Port Configuration button accesses the DSX-1 Port Configuration View.
The DSX-1 Port Configuration View provides the following information:
Port Diagnostics
Loop Up
Loop Down
Test Pattern
!
CAUTION
Enabling a loop back test on a remote NB30 will make the device non-
responsive to SNMP-Based commands, and you will lose contact. Loop back
testing should ONLY be enabled on LOCAL NB30 devices. You should always
be certain which NB30 is local and which is remote.
Port Configuration