User`s guide

Community Names Screen
IRM3 User’s Guide Page 4-17
Access
Indicates the access status of the workstations. The possible conditions
are as follows:
• RO (Read Only)
These workstations have read only access to the IRM3.
• RW (Read/Write)
These workstations have read/write access. They can read and write to
the IRM3, but they cannot change the IP address or the Community
Names.
• SU (Superuser)
This is the Superuser workstation. It has read/write access to the IRM3
and can change all parameters including IP Address and Community
Names. Multiple Superusers can be assigned to have access to the
IRM3. In addition, any Community Name given Superuser Access
will act as a password to Local Management.
• NA (No Access)
These workstations have no access (read/write) to the IRM3.
Trap IP Address
Indicates the IP address of the management workstations that will receive
alarms from the IRM3.
4.5.3 Editing the Community Names Screen
Make changes to the Community Names screen as follows:
1. Using the arrow keys, highlight the appropriate Community Name
field.
2. Enter the user defined name of the workstation, up to 32 characters in
length, into the field.
3. Press RETURN. The Access field will be highlighted.
!
CAUTION
Changing the factory default Superuser name, the RETURN
key, will change the password to Local Management. Any
Community name assigned Superuser access will be your
password to Local Management. Be sure to remember it.