User`s guide

Accessing Local Management Using a Terminal

IRM3 User’s Guide Page 4-3

4.1 ACCESSING LOCAL MANAGEMENT USING A

TERMINAL

This section describes how to access local management using a terminal.

Local Management for the IRM3 is accessed through a VT200 or VT300

series terminal, or terminals running emulation programs for these series

terminals. The terminal or emulating terminal is attached to the 9-pin port

labeled CONSOLE on the IRM3.

4.1.1 Conﬁguring a Local Management Terminal

The following section explains how to conﬁgure your terminal (console)

to communicate with Local Management. Refer to your speciﬁc terminal

manual for more instructions if necessary.

Table 4-1 lists the setup parameters necessary to conﬁgure your terminal

(console) to communicate with Local Management. If the terminal is a

Digital Equipment Corporation VT320 terminal, press F3 to access the

Setup Directory. If the local management terminal uses terminal

emulation of the VT320, refer to the equipment user manual for setup

procedures.

Table 4-1 Terminal Setup Parameters

Menu Function Selection

Display Setup

Columns 80 Columns

Controls Interpret Controls

Auto Wrap No Auto Wrap

Test Cursor Cursor

General Setup

Mode 7 Bit Control

Cursor Keys Normal Cursor Keys