User`s guide

Connecting the IRM3 to the Network
IRM3 User’s Guide Page 3-9
3.5.1 Connecting to the Network Through the AUI Port
Connect to the network through the AUI port by performing the following
steps:
1. Attach an external transceiver to the segment to which the AUI port
will be attached. Refer to the applicable transceiver manual.
2. Attach the female end of an AUI cable, no more than 50 meters in
length, to the transceiver.
3. Attach the male connector on the AUI cable (Figure 3-5) to the AUI
port on the IRM3.
4. Move the slide latchon the AUI port to secure it to the lock post on the
AUI connector.
.
Figure 3-5 Connecting to the AUI Port
!
CAUTION
Be sure to disable the SQE test function on the transceiver you
connect to the IRM3 AUI port. Failure to do so will result in
improper operation of the IRM3. Refer to the applicable
transceiver manual.
SLIDE LATCH
AUI PORT
AUI CONNECTOR
0494107
SLIDE LATCH
AUI PORT
AUI CONNECTOR