User`s guide

AT-8116 User’s Guide
C-5
Table C-7 Port Configuration Commands
get-port-cfg Display the configuration of all ports
set-port-dplex Set the port mode: full or half duplex
set-speed-sel Set the port speed : 10Mbps, 100Mbps or Asense
set-port-state Enable or disable a port when Spanning Tree algorithm
is not running
set-aggr-mode Enable or disable switch aggressive mode
Table C-8 Switching Statistics Commands
clr-cnt Clear the switch Ethernet and bridging counters
get-eth-cnt Get the Ethernet counters per port
get-colls-cnt Get the collision distribution counters per port
get-rmon-cnt Get the Ethernet RMON counters per port
get-sdist-cnt Get packet size distribution counters per port
get-mgm-brcnt Get the switching counters of the mgmt port
Table C-9 Spanning Tree Commands
get-stp Display the Spanning Tree session state
set-stp Enable/Disable Spanning Tree - for the next session
get-st-bcfg Retrieve the Spanning Tree Bridge parameters
get-st-pcfg Retrieve the Spanning Tree port parameter table
get-st-syscfg Retrieve the Spanning Tree System Ports configuration
set-br-prio Set the Spanning Tree bridge priority
set-br-maxage Set the Spanning Tree bridge MaxAge
set-br-hellot Set the Spanning Tree bridge HelloTime
set-br-fwdel Set the Spanning Tree bridge Forward Delay
set-prt-prio Set the Spanning Tree port priority
set-br-enb Set the Spanning Tree port enable/disable
set-br-pcost Set the Spanning Tree port path cost