User`s guide

Chapter 6: SNMP Traps Screen
Page 6-2 MicroMMAC Local Management User’s Guide
6.1 TRAP TABLE SCREEN FIELDS
The following definitions explain each of the SNMP Traps screen fields:
Trap Destination
Use this field to enter the IP address of the management workstation
designated to receive SNMP traps from the MicroMMAC.
Trap Community Name
Use this field to enter the community name of the management
workstation with the associated IP address.
Enable Traps
Use this field to enable the transmission of SNMP traps to the
management workstation.
6.2 SETTING THE SNMP TRAP DESTINATION
Each management workstation designated to receive SNMP traps from
the MicroMMAC must have a valid IP address and community name. To
set and enable SNMP trap destination, perform the following steps:
1. Use the arrow keys to highlight the Trap Destination field you want
to modify.
2. Type the IP address of the management workstation designated to
receive SNMP traps from the MicroMMAC. This address must be
entered in DDN format.
For example: 134.141.25.17
3. Press ENTER.
4. Use the arrow keys to highlight the Trap Community Name field (on
the same row as the Trap Destination field).
5. Type the community name of the management workstation.
6. Press ENTER.
7. Use the arrow keys to highlight the Enable Traps field (on the same
row as the Trap Destination and Trap Community Name you have just
configured). The default setting for this field is NO.