User`s guide

COM Port Applications
MicroMMAC Local Management User’s Guide Page 4-9
3. Press ENTER.
4. Use the arrow keys to highlight the SAVE command field.
5. Press ENTER. The Event Message field at the top of the screen
displays “SAVED OK.”
4.9.2 Configuring the COM Port Baud Rate
If you select SLIP as the COM port application, an additional field
appears to the right of the port field. This is the Baud Rate field. The Baud
Rate field allows the port operating SLIP to be set to the correct baud rate
for its modem connection.
To alter and set the SLIP baud rate, perform the following steps:
1. Use the arrow keys to highlight the COM X Baud Rate field.
2. Press SPACE or BACKSPACE to cycle through the available baud
rates for SLIP operation.
3. Press ENTER to select the desired baud rate.
4. Use the arrow keys to highlight the SAVE command field.
5. Press ENTER. The Event Message field at the top of the screen
displays “SAVED OK.”
Table 4-1 COM Port Application Settings
Setting Application
LM Local Management Session
UPS APC Power Supply SNMP Proxy
SLIP Serial Line Internet Protocol
UNASSIGNED Not Active
NOTE
The COM 1 and COM 2 ports support standard baud rates
between 300 and 19,200.