User`s guide

Chapter 2: Local Management Requirements
Page 2-2 MicroMMAC Local Management User’s Guide
2.2 MANAGEMENT TERMINAL SETUP REQUIREMENTS
Table 2-1 lists the setup parameters for the management terminal. If the
management terminal is a Digital Equipment Corporation VT320
terminal, press F3 to access the Setup Directory. If the management
terminal uses terminal emulation of the VT320, refer to the equipment
user manual for setup procedures.
Table 2-1 Terminal Setup Parameters
Menu Function Selection
Display Setup
Columns 80 Columns
Controls Interpret Controls
Auto Wrap No Auto Wrap
Test Cursor Cursor
General Setup
Mode 7 Bit Control
Cursor Keys Normal Cursor Keys
Communications
Setup
Transmit Transmit = 9600
Receive Receive = Transmit
XOFF any option
Bits, Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
Local Echo No Local Echo
Port
DEC-423, Data Leads
Only
Transmit any option
Auto Answerback No Auto Answerback
Keyboard Setup
Auto Repeat any option
Keyclick any option
Margin Bell Margin Bell
Warning Bell Warning Bell
Auto Answerback No Auto Answerback