Specifications

9031012 E6 Introduction
1-5
SPMA and the SEHI
•Chapter 6, Security, describes how to configure intruder protection for all
the MIMs installed in the SEHI-controlled hubstack, and how to configure
eavesdropper protection for any installed LANVIEWSecure hubs. You can
access the Security application from the icon menu, the Hub View, or the
command line.
For details on Generic SNMP (MIB I II), Community Names, TFTP
DownLoad, and Trap Table, refer to the following chapters in the SPECTRUM
Portable Management Application Tools Guide:
•Chapter 2, Using the MIB I, MIB II Tool, explains how to use this tool to
view and change MIB I and MIB II object ID values. You can use the MIB
I, MIB II Tool on any devices, including non-Cabletron devices, that
support MIB I or MIB II.
•Chapter 3, Using the Community Names Tool, explains Cabletron’s
“Component” structure of device MIBs, and describes how to change
device community names.
•Chapter 5, Using the TFTP DownLoad Tool, explains how to upgrade
firmware on Cabletron devices equipped with Flash EEPROMs.
•Chapter 6, Using the SNMP Traps Tool, explains how to establish which
network management workstations on your network will receive trap
alarms from a selected device, and also provides a brief overview of some
of the traps supported by Cabletron Systems’ devices.