Specifications

Clearing Duplicate Address Alarms for the LANtern NMM
Device View Novell LANtern Network Monitor
2-14 Management Module Guide
Changing LANtern NMM Representation Using the Menu Bar
To change the MIM representation of the LANtern NMM using the menu bar,
do the following:
1. Move the mouse pointer onto the LANtern NMM. Single click the left
mouse button to highlight the LANtern NMM.
2. Select the View menu, and select the Icon Subviews submenu. Select
either the Go Physical or Go Logical menu option from this submenu.
3. The LANtern NMM changes its MIM representation. A selected single
MIM appears to extend from the hub chassis.
Changing LANtern NMM Representations Using the Mouse
To change the MIM presentation of the LANtern NMM, using the mouse, do
the following:
1. Move the mouse pointer onto the LANtern NMM.
2. Double click the left mouse button.
3. The LANtern NMM changes its MIM presentation. A selected single MIM
appears to extend from the hub chassis.
Clearing Duplicate Address Alarms for the
LANtern NMM
If you have previously created a stand alone LANtern NMM icon and have
created an IRM or IRBM hub icon and configured the LANtern NMM installed
in that hub through the hub’s Device View, a duplicate address alarm
condition (yellow alert) now exists between both LANtern NMM icons. This
occurs because SPECTRUM views both the independent LANtern NMM icon
and the LANtern NMM installed in the hub icon as separate devices with the
same assigned IP address. To alleviate this alarm condition, you must clear
the duplicate alarm.
NOTE
Make sure that the mouse pointer is not on top of or next to a gauge or port
connector (depending on the initial MIM representation), otherwise a Port
Performance View will open.