Specifications

IRM2 or IRBM Hub Device Views
Device View Novell LANtern Network Monitor
2-4 Management Module Guide
System UpTime The time the hub has been active without failure
displayed in the following format:
days+hours:minutes:seconds
A condition status banner surrounding this information displays the condition
status color for the hub containing the LANtern NMM. Refer to Table 4-2 for
definitions of condition status colors.
In addition, the MMAC Device Panel provides two buttons that allow a user to
change the type of statistical information presented in the logical MIM
horizontal bar gauges for either the LANtern NMM or the entire hub, as
described in the following section. Figure 2-1 shows an example of an IRM2 or
IRBM MMAC Device Panel.
Figure 2-1. The IRM2 or IRBM MMAC Device Panel
LANtern NMM Logical MIM Representation
When a hub Device View is first opened, it displays each MIM in its logical
representation. The LANtern NMM logical representation provides gauge
and port information about the LANtern NMM installed in the Cabletron hub
instead of presenting a physical image. For information on a Device View’s
physical MIM representation, refer to the section titled “LANtern NMM
Physical MIM Representation.” Refer to the section titled “Changing MIM
Representations” for information on changing between logical and physical
MIM representations. Figure 2-2 provides an example of a LANtern NMM
Logical MIM Representation.
A LANtern NMM logical representation provides the following information
about the board and the ports on the board:
Board Name The name of the LANtern NMM.
Port Number The number of the port.
Port Status The current status of the port. The port status
conditions are shown in Table 2-1:
MMAC Device Panel
My Office
Location
Name
IRM3
Logical Gauges
Frames
Gauge Mode
Rates
Network Address
Device Type
System UpTime
132.177.118.24
Hub_CSI_IRM3
2+01:17:39