Specifications

Enterprise Configuration Manager (ECM)
Special Requirements for NT Users
SPECTRUM Software Release Notes Page 67
operations — captures, loads, and verifications. The Scheduler, however,
will not be able to perform these operations.
Cisco Router Requirements
If you are planning to work with Cisco routers in an NT environment, you
must perform additional steps after you install the Enterprise
Configuration Manager. Cisco routers use TFTP (Trivial File Transfer
Protocol) to transfer configuration files. Therefore, you have to make sure
your workstation is set up as a TFTP server.
To set up your NT machine to support TFTP after you install the
Enterprise Configuration Manager, do the following:
1 At the command prompt, navigate to the system32 directory under
the system root directory (which is likely to be the C:\Winnt
directory):
cd C:\Winnt\system32
2 Copy the *.dll files from the C:\Win32App\Spectrum\tftpboot
directory into this directory:
cp C:\Win32App\Spectrum\tftpboot\*.dll .
3 In MS Windows NT you can start up the tftpserver (located in the
C:\Win32App\Spectrum\tftpboot directory) in either of two ways:
• Double-click on the file name in File Manager or NT Explorer.
Tip:
Tip:
When Microsoft Internet Explorer 5.0 is installed on your PC, the
Windows NT 4.0 Schedule Service (Atsvc.exe) is upgraded to
the Task Scheduler Service (mstask.exe), which enables you to
assign different user accounts to run scheduled tasks. See
About the SPECTRUM Control Panel for more information
about configuring the Task Scheduler Service for scheduled
SPECTRUM tasks.