Specifications

Corrected & Current Management Module Anomalies
SPECTRUM Software Release Notes Page 158
Solution: When IDs do not match, users with read/create or read/write
access can set the global ID attribute from the VLAN Interface Detail view.
SPECTRUM will update the extremeVlanIfGlobalIdentifier MIB on the
device. This view is accessible by double-clicking an entry in the VLAN
Interface Table in the Extreme VLAN MIB view. The Extreme VLAN MIB
view can be launched off the ExtrVlanApp in the Application view.
Problem 2: VLAN fault isolation is not supported for Extreme Summit
switches running a version of ExtremeWare that is earlier than 6.0.
Solution: VLAN fault isolation will only work with devices running
ExtremeWare 6.0 or later due to a need to use extremeVlanStackTable,
which is supported in version 6.0 or later. VLAN information is available
via the ExtrVlanApp model in the Application view.
Problem 3: VLAN information may not be accessible from the VLAN List
menu selection in the Device Topology view.
Solution: The VLAN information is available via the ExtrVlanApp model
in the Application view. It is not available from the Device Topology view
because VLAN information is not supported for Extreme Summit switches
running a version of ExtremeWare that is earlier than 6.0.