Specifications

9032294 E2 Configuration Views
3-5
Hub Configuration View
The Hub Configuration view also provides the following buttons:
This button displays the Interface Setup View.
This button displays the ASCII Agent Information View.
Interface Setup View
This view displays the Interface Setup table and the Default Router IP
address. The Interface Setup table is described below.
Default Router IP
Displays the IP address of the default router to be used for sending IP
datagrams to the remote destinations which have no entry in the IP Routing
Table. This corresponds to an entry in the MIB-II IP Routing Table with a
Destination field of “0.0.0.0” (the default router) which is set up from this field
after a system restart.
Interface Setup Table
This table shows the IP address and network mask to be used in initializing
the IP Address Table on each network interface after the next system restart.
There is one entry per network interface. The Index is equivalent to the Index
in the Interface Configuration table in the Device Configuration view. Double-
clicking an entry in this table displays the Interface Setup View in which you
can update the IP Address and Network Mask for that entry.
Interface
Displays the number of the interface or port. It is equivalent to the Index in
the Interface Configuration table.
IP Address
Displays the IP Address of the interface or port.
Network Mask
Displays the IP network mask of the interface of port.
Interface Setup
Ascii Agent Info
NOTE
Changes to this field do not affect the IP Routing Table until after the next
system reset. To change the IP Routing Table without resetting, change it
directly. Change this filed only if you want the change to be permanent.