Specifications

SynOptics Series 3000 Events and Alarms
This table describes the event messages appearing in the Event Log, and any corresponding
Event and Alarm Messages SynOptics Series 3000 Hub
4-4 Management Module Guide
CsEvFormat/Event3600010b
{d "%w- %d %m-, %Y - %T"} - A board
power supply failure has been detected.
The power supply status is {I}.
CsPCause/Prob3600010a
A board power supply failure has been
detected.
CsEvFormat/Event3600010c
{d "%w- %d %m-, %Y - %T"} - A change
has been detected in a router’s standby
status. The standby status is {I}.
No probable cause message
CsEvFormat/Event3600010d
{d "%w- %d %m-, %Y - %T"} - A router
failure has been detected. The most
recent LED diagnostic status is {O}.
CsPCause/Prob3600010d
A router failure has been detected.
CsEvFormat/Event3600010e
{d "%w- %d %m-, %Y - %T"} - A station
on the ring is beaconing. The ring
segment number is {I 1}. The Upstream
Neighbor Address is {X 3}. The physical
location of the node is {I 5}. {t} (name -
{m}). (Trap type: 0x0e)-(event[{e}]).
CsPCause/Prob3600010e
A station on the ring is beaconing.
CsEvFormat/Event3600010f
{d "%w- %d %m-, %Y - %T"} - A new
active monitor has been detected. The
ring segment number is {I 1}. The
Upstream Neighbor Address is {X 3}.
Physical location of the node is {X 5}. {t}
(name-{m}). (Trap type: 0x16)-(event
[{e}]).
CsPCause/Prob3600010a
A new active monitor has been detected.
CsEvFormat/Event36000110
{d "%w- %d %m-, %Y - %T"} - Board
status LED off. Board status is {I 1}. {t}
(name-{m}). (Trap type: 0x16)-(event
[{e}]).
No probable cause message
CsEvFormat/Event36000111
{d "%w- %d %m-, %Y - %T"} - A station
has inserted into ring {I 1}, upstream
neighbor is {X 3}. {t} (name-{m}). (Trap
type: 0x16)-(event [{e}]).
No probable cause message
Table 4-1. SynOptics Series 3000 Events and Alarms (Continued)
Message in the Event Log
Alarm View Probable Cause
Message