Specifications

9030920 E6 Configuration Views
3-23
Device Configuration
SynOptics Agent Protocol Configuration View
IPX Address
Allows entry of the Agent’s administrative IPX address.
Ping Default Router Switch
Provides a button that allows you to control whether the agent periodically
sends out the ICMP echos (pings) to the default router(s). You may select from
Other (unknown or other), On (agent periodically sends out pings to the
default router(s)), or Off (agent will not send out the pings to the default
router(s)).
Ping Default Router Time
Allows entry of the time interval that the agent uses to send out the pings
periodically to the default router(s) to check if the router(s) are still reachable.
Management Protocol Mode
Provides a button that allows you to indicate the network transports over
which the agent accepts SNMP requests. This object only applies to agents
with IP and IPX dual stack support. This parameter will not take effect until
written into EEPROM and a reset or a restart is issued. You may select from
Other, IP, IPX, or IP_and_IPX.
Actual Management Protocol Mode
Indicates the network transports over which the agent currently accepts
SNMP requests.
Default Gateway
Allows entry of the Agent’s administrative default gateway IP address.
Secondary Default Gateway
Allows entry of the agent’s administrative secondary default gateway IP
address. This default gateway’s IP address is used when the primary default
gateway is determined unreachable.
Authorization Trap
Provides a button that allows you to Enable or Disable the use of
authentication error trap generation.
Reset
Provides a button that allows you to reset the agent status. You may select
Not_Resetting or Resetting. Writing a reset to this object resets the NMM and
performs a download and restart.
Restart
Provides a button that allows you to restart the agent status. You may select
Not_Restarting or Restarting. Writing a restart to this object restarts the
NMM. This initializes all the counters, re-reads the EEPROM data structure,
and starts executing from the beginning of the code.
!
CAUTION
Updating the Reset or Restart field restarts the hub and causes momentary
network interruption.