Specifications

9030920 E6 Configuration Views
3-21
Device Configuration
SynOptics Agent Download View
Current Information
Agent Status
Indicates the network management module online status.
Boot Protocol
Indicates the boot protocol used to load the module with its software.
Image Actual Source
Indicates whether the agent loaded code from the network or used a local
image. When the Image Load Mode is Local_As_Backup, this variable
indicates whether the network load was successful. Options are Other,
Remote_Image, or Local_Image.
Agent Mode
Provides a button that allows you to modify the module mode. You may select
Primary, Secondary, or Other.
Local Image Status
Indicates whether the agent has a valid local code image on board. An
EPROM checksum failure would cause the agent to return Invalid. This may
display as Other, Valid, or Invalid.
Agent Configuration Actual Source
Indicates whether the agent loaded configuration data from the network or
used the local configuration data.
Next Boot
Image Load Mode
Provides a button that allows you to indicate whether the agent should get
configuration data from the network (Remote_Boot), use the local
configuration data (Local_Image), or try the network first and then fall back
to local configuration if the network load fails (Local_As_Backup). This object
applies only to agents with boot prom support for agent configuration load
options. This parameter will not take effect until written into EEPROM and a
reset is issued.
Boot Mode
Provides a button that allows you to select the boot mode. You may select from
BOOTP or EEPROM.
Boot File
Allows entry of the name of the boot file that is sent to the file server during
boot time.
Agent Configuration Source
Provides a button that allows you to select whether the agent should get
configuration data from the network (Remote_Config), use the local
configuration data (Local_Config), or try the network first and then fall back
to local configuration if the network load fails (Local_As_Backup). This object