Specifications

Ethernet Configuration
Configuration Views SynOptics Series 3000 Hub
3-4 Management Module Guide
Ethernet Configuration
This menu selection provides access to the following views. These views
contain network configuration information for the SynOptics Model 3000
Series Ethernet hub device. To access these views, select Ethernet
Configuration from the Icon Subviews menu for the device and then one of
the following menu/view selections.
• Frames and Errors/SynOptics Ethernet Frame Sizes and Protocols View
• Frame Sizes and Protocols/SynOptics Ethernet Frame Sizes and
Protocols View
• NMM Table/SynOptics Ethernet NMM Table View
• Host Table/SynOptics Ethernet Host Table View
• Threshold/SynOptics Ethernet Threshold Table View
SynOptics Ethernet Frames and Errors View
This view displays pie chart statistics for frames and error breakdowns. For
information on pie charts refer to the SPECTRUM Views. This view also
displays the following information:
Board
A unique value for each board.
Port
The media connection type for this port.
Link
Whether the port is receiving link status.
Intercon
Whether the port is connected to a host or to an interconnect.
Part Status
The operational status of the port. Possible values are: enabled, partition,
autopartition, timedpartition, latSecPartition.
Good Frames
The number of good frames.
Alignment
A count of frames received by the concentrator that are not an integral
number of octets in length and do not pass the FCS check.
FCS
A count of frames received by the concentrator that are an integral number of
octets in length that do not pass the FCS check.