Specifications

NMM Nodes
Configuration Views SynOptics Series 3000 Hub
3-2 Management Module Guide
• FDDI Configuration
- SynOptics FDDI NMM Ring Status View
- SynOptics FDDI NMM Station Worst Errors View
- SynOptics FDDI NMM SRF Event Counters View
- SynOptics FDDI NMM SRF Condition View
- SynOptics FDDI NMM Ring Topology View
- SynOptics Physical Topology Trunk View
- SynOptics Physical Topology Node View
- SynOptics NMM Optical Bypass Switch View
• Device Configuration
- SynOptics Configuration View
- SynOptics Agent Download View
- SynOptics Agent Protocol Configuration View
- SynOptics Agent Configuration View
- SynOptics Agent Hardware View
- SynOptics IP Trap Receiver View
- SynOptics IPX Trap Receiver View
• SynOptics Chassis Configuration View
• SynOptics Ethernet Local Bridge Configuration View
See Chapter 1, Introduction, for information on Accessing SPECTRUM Views.
NMM Nodes
This menu selection from the device icon provides access to the following
NMM nodes views. To access these views, select NMM Nodes from the Icon
Subviews menu for the device and then one of the following menu/view
selections:
• Show Nodes/SynOptics Token Ring Show Nodes Table View
• Find Nodes/SynOptics Token Ring Find Nodes Table View
SynOptics Token Ring Show Nodes Table View
This table contains a list of all of the active nodes that are currently connected
to the ring through this concentrator. To access this view, select Show Nodes
from the NMM Nodes menu for the device icon.
Module
The board number.