Technical data

Table Of Contents

168

1 is the number of the VPI as found in the ATM stream.

2 is the number of the VCI as found in the ATM stream.

The discovered number may be used as the VPI*VCI value in the remote, to determine if communications are

possible.

REMOTE SETATMTRAFFIC

This command sets ATM traffic shaping on a remote router. ATM traffic shaping allows the user to set the

average rate at which cells are sent (SCR, Sustained Cell Rate) to a value lower than the ATM link speed (PCR,

Peak Cell Rate).

Note 1:

This command can only apply to one remote router. ATM traffic shaping must be used if more than one

remote router is defined.

Note 2:

ATM traffic shaping can be disabled with

remote setATMTraffic 0 0

SCR Sustained Cell Rate (cells per second).

MBS Maximum Burst Size (cells).

remoteName

Name of the remote router (character string).

Examples:

Assume that the ATM link speed (upstream) is 200 Kb/second or 471 cells/second and an average

upstream data rate of 20 Kb/second (47 cells/second) is desired, then the following command would be

used:

remote setatmtraffic 47 31 HQ

To disable ATM traffic shaping on HQ, use:

remote setatmtraffic 0 0 HQ

remote setATMTraffic

SCR MBS