Technical data

125
Target Router System Configuration Commands (SYSTEM)
The following commands set basic router configuration information:
• name of the router
• optional system message
• authentication password
• security authentication protocol
• management security
• system administration password
• IP address translation
• NAT configuration
• Host mapping
• WAN-to-WAN forwarding
• filters
SYSTEM ?
Lists the supported keywords.
Response:
? msg name
passwd authen community
list admin history
log addServer addHostMapping
delServer delHostMapping addTelnetFilter
delTelnetFilter addSNMPFilter delSMNPFilter
bootpServer supportTrace telnetport
snmpport wan2wanforwarding addUDPrelay
delUDPrelay securityTimer oneWANdialup
addHTTPFilter delHTTPFilter
SYSTEM ADDHOSTMAPPING
This command is used to remap a range of local-LAN IP addresses to a range of public IP addresses on a system-
wide basis. These local addresses are mapped one-to-one to the public addresses.
Note:
The range of public IP addresses is defined by <first public addr> only. The rest of the range is computed
automatically (from
<first public addr
> to
<first public addr>
+ number of addresses remapped - 1) inclusive.
system ?