Network Cables User Manual

Using the EMM-E6 Hub View

2-4 Using the Hub View

Figure 2-2. EMM-E6 Hub View Device Menu

The Device menu lets you perform the following:

• Open the Device Status window

• Access the IP Address Table

• Open the Polling Intervals window

• Change the Port Display Form

• Launch the Global Find MAC Address Tool

• Start the Alarm Conﬁguration application

• Start the Link/Seg Traps application

• Start the Repeater Redundancy application

• View the Source Address List

• Access the Security application

• Start the Front Panel Redundancy application

Note that the Device menu does not provide access to every application available

to the EMM-E6. Some information is only available from the Network, Module,

and/or Port menus, and several applications can only be accessed either from the

icon menu (if you are running under a network management platform) or from

the command line (if you are running in stand-alone mode). See Chapter 1,

Introduction, for a complete list of applications available to the EMM-E6 and how

to access each one.