- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps

Bridge MIB
4-7
by 802.1d/D9 to be 1 second. An agent may return a badValue
error if a set is attempted to a value which is not a whole number
of seconds.
The Forward Delay Time must be at least 4 seconds, and must
adhere to the aforementioned equation involving Max Age Time
and Forward Delay Time.
dot1dStpPortTable {dot1dStp 15}
Not Accessible
A table that contains port-specific information for the Spanning
Tree Protocol.
All ELS10-26 ports, except for the last port (port 25), are included
in this table, regardless of whether the Spanning Tree Protocol is
currently enabled for the ports.
dot1dStpPortEntry {dot1dStpTable 1}
Not Accessible
A list of information maintained by every port about the Spanning
Tree Protocol state for that port.
dot1dStpPort {dot1dStpPortEntry 1}
Integer Read-Only
The port number of the port for which this entry contains
Spanning Tree Protocol management information.
dot1dStpPortPriority {dot1dStpPortEntry 2}
Integer Read-Write
The value of the priority field which is contained in the first (in
network byte order) octet of the (2 octet long) Port ID. The other
octet of the Port ID is given by the value of dot1dStpPort.
Any value from 0 to 255 may be specified.










