- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps

3-4
Ethernet MIB
dot3StatsSQETestErrors {dot3StatsEntry 6}
Counter Read-Only
The number of times an SQE failure (i.e., heartbeat lost) occurred,
since the port was last enabled.
dot3StatsDeferredTransmissions {dot3StatsEntry 7}
Counter Read-Only
The number of frames for which the first transmission attempt was
successful, but delayed because the medium was busy.
dot3StatsLateCollisions {dot3StatsEntry 8}
Counter Read-Only
The number of times that a late collision was detected while the
ELS10-26 was transmitting a frame.
dot3StatsExcessiveCollisions {dot3StatsEntry 9}
Counter Read-Only
The number of times a frame transmission attempt experienced
excessive collisions, since the port was last enabled.
dot3StatsInternalMACTransmitErrors {dot3StatsEntry 10}
Counter Read-Only
The number of times a frame transmission attempt experienced an
error other than dot3StatsSQETestErrors,
dot3StatsExcessiveCollisions, or dot3StatsCarrierSenseErrors,
since the port was last enabled.
dot3StatsCarrierSenseErrors {dot3StatsEntry 11}
Counter Read-Only
The number of times that a carrier sense condition was lost during
a transmission attempt, since the port was last enabled.










