- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps

3-1
CHAPTER 3
ETHERNET MIB
The ELS10-26 supports the Ethernet MIB as defined in Definitions of
Managed Objects for the Ethernet-like Interface Types, RFC 1284
(J. Cook, editor), dated December 1991.
The MIB tree prefix for reaching the GenericIF group is:
1.3.6.1.2.1.12.
3.1 GENERIC ETHERNET-LIKE GROUP
dot3Table {dot3 1}
Not Accessible
A list of interface entries; one per Ethernet port. The entry
instances correspond to the ELS10-26’s port numbers.
dot3Entry {dot3Table 1}
Not Accessible
A set of operational attributes for an Ethernet entry. The individual
components are described below.
dot3Index {dot3Entry 1}
Integer Read-Only
The ELS10-26’s Ethernet port number.
dot3InitializeMAC {dot3Entry 2}
Integer Read-Write
Whether the port has been initialized. Initializing a port
automatically resets all of the port’s statistics, and enables transmit
and receive (the receiver will be in promiscuous mode). The value
of dot3InitializeMAC is not saved in the event that the ELS10-26
reboots. Values include:
• initialized (1)
• uninitialized (2)










