- Cabletron IP Router Reference Guide
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- TCP/IP MIB-II
- 2.1 System Group
- 2.2 Interfaces Group
- 2.3 Address Translation Group
- 2.4 IP Group
- 2.5 ICMP Group
- 2.6 TCP Group
- 2.7 UDP Group
- 2.8 EGP Group
- 2.9 OIM Subtree
- 2.10 Transmission Group
- 2.11 SNMP Management Group
- 2.12 Enterasys Interface Group
- 2.13 Enterasys Interface Port Group
- 2.14 Enterasys Com Port Configuration Group
- 2.15 SNMP Version Group
- 2.16 Trap Description
- 2.17 Enterasys MIB 2 Extensions
- Ethernet MIB
- Bridge MIB
- PPP MIB
- ELS10-26 MIB
- 6.1 System Group
- 6.1.1 Hardware Configuration Group
- 6.1.2 LXSW Configuration Group
- 6.1.3 Administration Group
- 6.1.4 Software Distribution Group
- 6.1.5 Addresses Configuration Group
- 6.1.6 Enterasys Interfaces Group
- 6.1.7 Enterasys Dot3 Group
- 6.1.8 Enterasys UART Interface Group
- 6.1.9 Enterasys Protocol Group
- 6.1.10 Enterasys Trunking Group
- 6.1.11 Enterasys Workgroup Management Group
- 6.1.12 Enterasys Trap Management Group
- 6.1.13 Ping Management MIB
- 6.1.14 Traceroute
- 6.1.15 Traceroute Management MIB
- 6.1.16 Port Mirroring
- 6.1 System Group
- Traps

2-46
TCP/IP MIB-II
DESCRIPTION Defines whether or not an interface
supports redundancy.
::= {ctIfEntry 7}
ctIfPort group implementation of this group is optional
The ctIfPort group contains information about the type of port on
the interface i.e., the type of EPIM,TPIM etc. This information is
not available in the interface group of MIB-II.
ctIfPortTable
OBJECT-TYPE
SYNTAXSEQUENCEOF CtIfPortEntry
ACCESS not accessible
STATUS mandatory
DESCRIPTION This defines each conceptual row
within the ctIfPortTable.
INDEX {ctIfPortNumber}
ctIfPortPortNumber
::= {ctIfPortTable 1}
ctIfPortEntry
OBJECT-TYPE
SYNTAX {CtIfPortPortNumber}
ACCESS not accessible
STATUS mandatory
DESCRIPTION This defines each conceptual row
within the ctIfPortTable.
INDEX {ctIfPortNumber}
ctIfPortPortNumber










